Monday, May 29, 2017

Waterjet cutter built with a cheap pressure washer



Building an abrasive waterjet cutter with a $150 pressure washer.

Water orifice, mixing tube (nozzle), cutting head, high pressure fittings, valve: https://www.accustream.com/

80 grit garnet abrasive - ebay
eg http://www.ebay.com/itm/40-LBS-Garnet-80-grit-coarse-med-sand-blasting-abrasive-Fast-Cutting-Media-/272599344178

Sun Joe pressure washer: https://www.amazon.com/Joe-SPX3000-Pressure-14-5-Amp-Electric/dp/B00CPGMUXW

Pressure gauge - https://www.mcmaster.com/#4053K15

Good waterjet background and design info: https://wardjet.com/waterjet/university/nozzle-orifice

Good selection of higher-end pressure washers: https://www.pressurewashersdirect.com/

Wikipedia waterjet cutter (diagram image source): https://en.wikipedia.org/wiki/Water_jet_cutter


Support more Applied Science videos: https://www.patreon.com/AppliedScience

6 comments:

  1. Hi Ben,
    It should be nice if you could to create a video explaining how build the waterjet cutter. Thank you very much! BR, Alan

    ReplyDelete
  2. Very cool build Ben. Thanks for the share

    ReplyDelete
  3. Great build, Ben. Have you thought about actually building a hydraulic intensifier? I think that there is a niche opportunity less than 50kpsi and greater than typical limits of commercial/household pressure washers.

    I don't know the answer to this question, but what are the pressure limits for hydraulic compression using a multi disc 'tesla type' pump? might this be something to consider? Doug

    ReplyDelete
  4. Nice job Ben! Just started a build myself and intend to go the CNC route. Was there anything special about the plunger you turned with the larger inside diameter? How much larger did you make it? I all ready have the x-y table ready for the cutting nozzle setup but I'm still aways away. Any thoughts or help would be appreciated, thanks!

    ReplyDelete
  5. Hello Ben. Just wanted to know your oppinion on this: https://www.wazer.com Cheaper than the factory ones.
    Thanks in advance

    ReplyDelete